Technical Specifications - tws EP011 Mode D'emploi

EN

TECHNICAL SPECIFICATIONS:

Bluetooth version: 4.2
Wireless range: do 9 m
Input voltage: 3.3~4.2V
Charging port: Micro USB
Charging case capacity: 350 mAh
Battery capacity: 70 mAh
Charging time: 2 h
Listening time: 3 h
Stand-by time: 20 h
POWERING ON / OFF
1. Powering on the TWS earphones: press and hold down the power button for 3-4 seconds,
release when the LED indicator lights up.
2. Powering off the TWS earphones: the earphones power off automatically when placed
in the charging case. They can be powered off manually as well by pressing and holding
down the start button for 3-4 seconds.
CHARGING STATION AND EARPHONES CHARGING
1. Charging your charging station: press the start button on your charging station and check
the battery level. 4 LED indicators show 75 – 100% power, while a single diode shows
power of less than 25%. To charge the charging station use the attached USB cable. Plug
the smaller end of the cable into a USB port of the charging case and the other one into any
USB (5V) port of a computer/car charger/ wall charger etc.
The LED indicator shows the battery level while charging. When the device is fully charged, the LED
indicator turns off. The approximate charging time is 2 hours.
Note: The charging station and the TWS earphones can be charged simultaneously.
2. Charging your earphones: Checking „L" and „R" indicator on the charging case place left
and right earphone in the correct compartment, making sure that the magnetic charging
contactor line is positioned properly. While charging, the built-in LED indicator on the
earphones lights up in red and the LED diode on the charging case – in blue. After the
earphones are fully charged, the built-in LED indicator turns blue and then turns off after
approximately 5 minutes.
Note: If charging doesn't start automatically, press start button on the charging station.
SYNCHRONIZATION
1. When the TWS earphone is off, press and hold down the button, until the LED diode starts
TWS EP011