Adjusting The Grinder - Jura IMPRESSA A9 One Touch Mode D'emploi

Masquer les pouces Voir aussi pour IMPRESSA A9 One Touch:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

E It is not possible to prepare two ristretti, two
espressi or two coffees with ground coffee.
E Use ground coffee which is not ground too
finely. Very fine coffee can block up the
system so that the coffee only comes out in
drips.
E If you did not fill the machine with a
sufficient amount of ground coffee,
enough ground coffee'
IMPRESSA stops the operation.
E The desired specialty coffee must be
prepared within approximately one minute
after filling with the ground coffee.
Otherwise the IMPRESSA stops the operation
and is once more ready for use.
Example: Proceed as follows to prepare one
espresso using ground coffee.
T Place an espresso cup under the coffee
spout.
T Open the powder chute cover.
'Please add ground coffee'
T Fit the filler funnel for ground coffee on the
powder chute.
T Place one level measuring spoon of ground
coffee into the filler funnel.
T Close the cover of the powder chute.
The start screen is displayed.
T Touch 'Espresso'.
Preparation starts. The preset amount of
water for espresso flows into the cup.
Preparation stops automatically. Your
IMPRESSA is once more ready for use.
'Not
is displayed and the

Adjusting the grinder

You can adjust the grinder on a continuous scale to
suit the degree of roast of your coffee.
NOTICE
If you adjust the consistency of grind when the
grinder is not operating, the grinder adjustment
switch could be damaged.
T  Only adjust the consistency of grind when
the grinder is running.
The consistency of grind is correct if the coffee
flows regularly from the coffee spout. In addition a
fine, thick crema forms.
Example: Proceed as follows to change the
consistency of grind during the preparation of an
espresso.
T Place a cup under the coffee spout.
T Open the cover of the grinder adjustment
switch.
T Touch 'Espresso'.
The coffee strength is briefly displayed.
The grinder starts up.
T Turn the grinder adjustment switch to the
desired position while the grinder is
running.
The espresso is prepared and the consist-
ency of grind is adjusted.
T Close the cover of the grinder adjustment
switch.
E Please note that the new consistency of
grind only takes effect when the second
beverage is prepared.
de
2 Preparation
en
fr
es
pt
es
pt
ru
17

Publicité

Table des Matières
loading

Table des Matières