Jura IMPRESSA A9 One Touch Mode D'emploi page 12

Masquer les pouces Voir aussi pour IMPRESSA A9 One Touch:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1 Preparing and using for the first time
T Touch 'Next'.
'Filter is being
rinsed', water flows out of the
hot-water spout.
E The water may be slightly discolored. This is
not harmful to health and does not affect
the taste.
Rinsing of the filter stops automatically after
approximately 10 oz (300 ml).
'Welcome to JURA'
'System is
filling', the system fills up with
water. Water flows out of the hot-water
spout and the dual spout. The operation
stops automatically.
'Machine is heating'
'Machine is
rinsing', the machine rinses. The
operation stops automatically. Your
IMPRESSA is ready for use.
E The display shows the products you can
prepare.
First-time use without filter cartridge
activation
NOTICE
Milk, sparkling mineral water or other liquids can
damage the water tank or the machine.
T  Only fill the water tank with fresh, cold water.
T Touch 'Save'.
'Saved'
appears briefly on the display.
'Water hardness'
E If you do not know the hardness of your
water, you must find this out first (see
Chapter 1 'Preparing and using for the first
time – Determining the water hardness').
T Touch
' < '
or
' > '
hardness.
T Touch 'Save'.
'Saved'
appears briefly on the display.
'Fill water tank'
12
to adjust the water
T Remove the water tank and rinse it with cold
water.
T Fill the water tank with fresh, cold water and
reinsert the tank.
'Welcome to JURA'
'System is
filling', the system fills up with
water. Water flows out of the hot-water
spout and the dual spout. The operation
stops automatically.
'Machine is
rinsing', the machine rinses.
The operation stops automatically. Your
IMPRESSA is ready for use.
E The display shows the products you can
prepare.
Determining the water hardness
You can find out what the water hardness is by
using the Aquadur® test strip supplied as standard.
T Hold the test strip briefly (for 1 second)
under flowing water. Shake off the water.
T Wait for about one minute.
T You will then be able to read the degree of
water hardness from the discoloration of the
Aquadur® test strip and the description on
the packaging.

Publicité

Table des Matières
loading

Table des Matières