Chibli SB133 Utilisation Et Entretien page 30

EN IT
4.1 ADJUSTING HANDLE
TILT
WARNING:
The handle position must be adjusted
while the appliance is at a standstill.
- By pulling the lever (63), it is possible
to vary the position of the handle (62).
When the lever is released, the handle is
positioned and locked in the closest fixed
position.
N.B.:
The correct position of the handle (62) during
machine operation is at hip height.
Never start the machine without having tilted
the handle correctly.
5.1 GUIDE HANDLE
(Figs. 21 and 23)
1) Brush rotation lever release button
(56) (Fig. 21)
Press the button (56) to release the brush
rotation start levers (52).
2) Brush rotation start levers (52)
(Fig. 21)
Pulling the brush rotation levers (52) ena-
bles brush rotation.
When the levers (52) are released, brush
rotation stops and the machine comes to
a halt automatically.
The levers (52) should be kept pulled to
achieve continuous machine operation.
3) Water supply adjustment lever (53)
(in the presence of an optional tank)
(Fig. 23)
Pulling the lever (64) activates the water
supply for washing the floor.
When the lever is released (64) the water
supply is interrupted.
(Fig. 22)
6.1 OPERATION
6.1.a - Checks before use (Fig. 18)
- If the suction unit (optional) is assem-
bled, check that the suction tubes (48)
are properly connected to the base of the
machine and the aspirator.
- Check that the fittings on the base of the
machine are not blocked.
- If the tank (optional) is assembled, check
that it contains enough washing liquid for
the working phase and that the tubes are
properly connected.
- Check the condition of the brush or pad.
If worn, replace them.
- Check that the appliance, particularly the
mains cable, is not damaged in any way
that might compromise correct machine
operation or operator safety.
6.1.b - Starting the machine (Fig. 21)
WARNING:
Some machine models have two speed
settings.
In this case, select the desired speed be-
fore turning on the machine.
DANGER:
Ensure your hands are dry before using the
appliance.
- Pull up the lever (54) and lower the han-
dle until it reaches the height of the hips
(maximum balance position).
- Press the button (56) to release the brush
rotation start levers (52).
- Pulling the levers (52) starts the ma-
chine.
- When both levers (52) are released, the
machine stops.
WARNING:
Never wrap the power cable around the
neck or body of the machine.
EN - 6