NEFF CV 7760 N Mode D'emploi page 35

: Each time a new water filter
Water filter
is inserted in the water tank (8), it must be
rinsed:
1. Place the water filter in the water tank
(8) and fill the tank with water up to the
"max" mark.
2. Use the navigation button
and press
START
3. Place a container with a capacity of 0.5
litres under the milk frother (19).
4. Press (6). Water will now run first
through the filter to rinse it and then into
the container.
Empty the container. The appliance is ready
to use once more.
The filter is no longer effective when the
Change filter display appears, or at the
latest after two months. It needs to be
replaced for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance). Replacement filters
can be obtained from retailers or customer
service (see "Accessories").
After every filter change the filter must first
be rinsed. Proceed as described at the
beginning of this section.
If no new filter is used, turn the water filter
setting to Off .
If the appliance has not been used
for a prolonged period (e.g. during
your vacation) the filter should
be rinsed before the appliance
is used again. To do this, simply
dispense a cup of hot water.
Neff
All manuals and user guides at all-guides.com
Further entries in the Settings menu:
Service - descale
the appliance, press
descaling programme (see "Descaling").
Service - clean
appliance, press
to select ing programme (see "Cleaning").
(6).
Service - Calc'n'Clean
scale and clean the appliance at the same
time, press
programme (see "Calc'n'Clean").
Factory settings
settings and reset the factory settings. To
activate the factory settings, press
1. Switch the appliance off fully at the
2. Press
The factory settings are reactivated.
Adjusting the grinding unit
The rotary selector (11) on the top of the
appliance adjusts the degree of grinding
from coarse to fine as required.
: If you want to descale
(6) and run the
: If you want to clean the
(6) and run the clean-
: If you want to de-
(6) and run the Calc'n'Clean
: You can cancel your own
The appliance can also be reset
to the factory settings as follows:
power switch (7).
O/I
(2) and (5) at the same
time, hold them down, and switch the
appliance on again at the power switch
O/I (7).
11
Warning:
Adjust the grinding unit only while
it is running. Otherwise the appli-
ance may be damaged.
English | 35
(6).
C77V60N01 | 09/2008