Install The Software Driver On Pc; Pcmcia Interface Installation - Archos CESAR MPM Guide D'installation

All manuals and user guides at all-guides.com

3..Install the Software Driver on PC

Using CESAR for the first time requires a driver installation,
depending on the version of interface (PCMCIA, USB, USB2 or Fire
Wire). Each driver installation is different.
A. PCMCIA Interface Installation
NOTE : For the PCMCIA interface, default Windows driver
are used.
The floppy disk driver is not required for this installation.
Windows 95, Windows 98, Windows 98SE & ME :
• Turn on your system and wait for Windows to finish booting.
• Insert the PCMCIA card (Archos logo face up) into an open
PCMCIA slot in your notebook.
• A "New Hardware Found" window will guide you through
installation of driver. When prompted for driver disk,
uncheck all boxes. Then click Next.
• For Windows 98 (4.10.1998) choose "The updated driver
recommended" and click Next:
Windows 2000 :
•
Turn on your computer and wait for Windows to finish
booting.
•
Insert PCMCIA card (Archos logo face up) into an open
PCMCIA slot in your computer.
Follow steps listed below to complete installation:
1. Found new hardware wizard will pop up. System will install
ARC ATAPI,
PCMCIA IDE/ATAPI Controller,
ARCHOS SlimCDRW 8824 and
CD-ROM Drive using standard Windows drivers.
No driver files will be needed from Archos.
2. You must restart your computer before the new settings will take
effect.
- 7 -