Installation Instructions - GE AET05 Manuel D'utilisation Et Instructions D'installation

Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit www.GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
IMPORTANT
•
for local inspector's use .
IMPORTANT
•
codes and ordinances .
• Note to Installer – Be sure to leave these
instructions with the Consumer .
• Note to Consumer – Keep these instructions for
future reference .
• Skill level – Installation of this appliance
requires basic mechanical skills .
• Completion time – Approximately 1 hour
• We recommend that two people install
this product .
• Proper installation is the responsibility
of the installer .
• Product failure due to improper installation is not
covered under the Warranty .
• You MUST use all supplied parts and use proper
installation procedures as described in these
instructions when installing this air conditioner .
ELECTRICAL REQUIREMENTS
Some models require a 115/120-volt AC,
60-Hz grounded outlet protected with a
15-amp time-delay fuse or circuit breaker .
The 3-prong grounding plug minimizes the
possibility of electric shock hazard . If the wall outlet you
plan to use is only a 2-prong outlet,
it is your responsibility to have it replaced with
a properly grounded 3-prong wall outlet .
Some models require 230/208-volt AC,
protected with a time-delay fuse or circuit
breaker . These models should be installed on
their own single branch circuit for best
performance and to prevent overloading
house or apartment wiring circuits, which
could cause a possible fire hazard from
overheating wires .
All manuals and user guides at all-guides.com
— Save these instructions
— Observe all governing
Air Conditioner
CAUTION:
Do not, under any circumstances, cut or remove the
third (ground) prong from the power cord.
Do not change the plug on the power cord of this air
conditioner.
Aluminum house wiring may present special
problems—consult a qualified electrician.
TOOLS YOU WILL NEED
Phillips head screwdriver
Flat-blade screwdriver
Pencil
Level
Power cord includes a current interrupter
device . A test and reset button is provided on the
plug case . The device should be tested on a periodic
basis by first pressing the TEST button and then the
RESET button while plugged into the outlet . If the
TEST button does not trip or if the RESET button will not
stay engaged, discontinue use of the air conditioner
and contact a qualified service technician .
7
Ruler or tape measure
Scissors or knife