Publicité
Les langues disponibles
Les langues disponibles
Fitting & operation information:
Please refer to the instruction diagrams (P. 51 - 62):
Chassis
Front wheel
Rear wheel
Brake
Front wheel swivel
lock
Basket
Chassis
Middle adaptor
Carrycot
Carrycot hood
Hood pocket (Style
may vary)
Viewing Windows
(Style may vary)
Carrycot
1-
Opening:
Release the autolock (a) and lift the handle upwards until the chassis locks into
position (b).
Check the chassis has locked in place.
2-
Adjusting handle position:
3-
Fitting:
4-
Removing:
5-
Fitting:
6-
Removing:
7-
Applying:
8-
Releasing:
9-
Applying:
10-
Releasing:
11-
Accessing rear compartment:
12-
Closing:
NOTE: The chassis cannot be closed in pram mode or car seat mode.
To close with seat unit fitted, the seat unit must be forward facing and in the most
upright recline position.
While pressing the primary release button (a), pull both secondary levers (b) back.
Press down on the handle (c) until the autolock retains the chassis in the folded
position (d).
Adjust the handle to the lowest position (See Step 2) for the most compact fold.
NOTE: To avoid damage in transit, the rear adaptors and front adaptors should be
removed prior to folding.
13-
Fitting:
Preparation:
14-
Remove mattress and liner from carrycot (a).
Unfold both frame bars until they locked into positions (b).
15-
Refit the liner into the carrycot (a) and secure the zip fasteners (b).
Refit the mattress over the liner in the carrycot (c).
Push the "D" rings through the slots in the liner (d).
16-
Opening:
17-
Closing:
18-
Opening:
19-
Closing:
20-
Opening:
21-
Closing:
22-
Note: When use in single mode, the carrycot can only be fitted rearward facing as
shown in illustration.
23-
Fitting:
Dots are marked on the chassis mounts and carrycot mounts (a). These should be
on the same side and aligned if fitted correctly.
4
Publicité
