Publicité
1. BEFORE USE
Unpack your ceiling fan carefully then remove all parts and components and lay on a cloth or soft
surface to avoid damage. Do not lay the motor housing on its side, the housing may get damaged.
Before commencing installation, check that all parts are included.
2. PRODUCT ASSEMBLY
WARNING: All electrical tasks should only be undertaken after disconnection of electricity by
removing fuses or turning off the circuit breaker to avoid risk of electric shocks.
ASSEMBLY STEPS:
2.1. INSTALLATION OF THE MOUNTING BRACKET
The hanger bracket must be screwed on to a firm flat surface. The structure to which it is installed
must be able to withstand ten times the static weight of the fan. In case of installing the ceiling fan
to a wooden joist, 2 self-tapping screws provided should be enough to support the ceiling fan. The
washers provided must be placed in the following Order:
screw head > round washer > spring washer > mounting bracket
> ceiling.
1. Concrete ceiling: Drill two holes with an appropriate depth by a drilling
bit with diameter 8mm, and insert 1 piece of expansion screw to each
hole, then fix the mounting bracket into the expansion screws, and tight-
en it with the nuts of expansion screws. (Fig 2)
2. Wooden ceiling: Fix the mounting bracket to the wooden ceiling by 4
pieces wooden screws. The thickness of wooden ceiling must be at least
7cm. (Fig 3)
NOTE: Do not install mounting bracket on the roof leaking and damp.
The ceiling must be able to with stand the weight of 40kgs or more.
ENGLISH
Publicité
