Black & Decker JC120 Mode D'emploi page 6

ENGLISH
• To switch the appliance off during boiling,
push the On / Off switch (2) the off position
(O).
• If you do not want to use the boiled water
immediately, the kettle may be left on the
base. If you want to bring the water back to
boil after a while, push the on / off switch (2)
to on again.
Pouring boiling water
• Make sure the appliance is switched off.
• Take the kettle off the base.
• To avoid scalding, tilt the kettle slowly to pour
the boiled water.
• After pouring, place the kettle back on the
base and remove the plug from the socket.
Cleaning and maintenance
Before cleaning and maintenance, remove the
plug from the socket and allow the appliance to
cool.
Warning! Before cleaning and maintenance,
switch the appliance off, remove the plug from
the socket and allow the appliance to cool.
Warning! Do not immerse the appliance, the
base, the cord set or the plug in water or any
other liquid.
• Wipe the exterior with a damp cloth.
• Do not use scouring pads.
• The filter in the pouring spout (3) can be
lifted out and cleaned with warm water.
• If necessary, use a mild detergent to remove
spots.
6
• Do not use any abrasive or solvent based
cleaner.
• Do not immerse the appliance in water or any
other liquid.
Technical data
Voltage
Supply
Power consumption
Cable length
Capacity
Weight
JC120
220-240V
50/60Hz
1000-1200W
0.94 metres
1.0 litres
0.85 kg