Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8
Installing the Print Head
Instructions are now shown on the touch screen regarding print head installation. Install the print head by following the instructions.
1
Open the top cover.
Important
● Do not move the carriage (the area enclosed by a circle in the
diagram). If you accidentally move it, temporarily close the top
cover and it will return to its original position.
3
Open the print head locking cover
instructions on the screen and tap OK. Do not touch the
electrical contacts of the carriage.
5
Remove the orange protective caps in the order shown in the diagram.
Important
● Do not touch the part that was being protected by the protective cap (part shown shaded in the diagram) under any
circumstances. Touching it may cause damage to the print head or printing problems.
● The print head is filled with ink. Be careful to avoid getting your clothes and surrounding items dirty when removing the
protective caps. It is recommended that you remove the protective caps above the bag that contained the print head.
● Do not reattach the protective caps after removing them. Furthermore, dispose of them according to local regulations.
by following the
Do not touch here
Hold here to remove
8
2
Tilt the print head lock lever
4
Grasp the print head as shown in the diagram and
remove it from the bag.
towards you.
Hold here
Publicité
Table des Matières
