Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• N-Male to F-Female adapter
Kit 314473-0640
• 75 Ohm Pole Mount
Panel Antenna
• 40' RG6 Cable
Kit 314475-0630
• 75 Ohm Wide
Band Directional
• 30' RG6 Cable
Kit 311141-0620
• 75 Ohm Grey Brick Antenna
• 20' RG6 Cable
Signal Booster Specifications
Model Number
Connectors
Antenna Impedance
Frequency
Passband Gain (typical)
20 dB Bandwidth (MHz)
Typical
Maximum
Power output for single cell
phone (Uplink) dBm
Power output for single cell
phone (Downlink) dBm
Power output for multiple
received channels (Uplink) dBm
No. Tones
Power output for multiple
received channels
(Downlinklink) dBm
No. Tones
Noise Figure
Isolation
Power Requirements
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory
reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase
coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected. If a
detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn the power
off on that band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (five)
such automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually restarted by momentarily
removing power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster's microprocessor.
The Manufacturer's rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the
rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users.
This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.
Need help?
Kit 301111-11140
• Yagi Directional Antenna
• 140' RG11 Cable
• N-Male to F-Female adapter
Kit 311201-1120
• Omni Directional
w/ F-Female
• 20' RG11 Cable
Kit 311129-11110
• 800 MHz Yagi Directional
• 110' RG11 Cable
• N-Male to F-Female adapter
698-716 MHz, 746-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
700
Band12/17
700
MHz
MHz
11.8
11.0
700
Band12/17
700
MHz
MHz
29.5
31.6
33.9
33.9
700
Band12/17
700
MHz
MHz
24.7
24.9
700
Band12/17
700
MHz
MHz
-6.3
-6.5
700
Band12/17
700
MHz
MHz
2
26.1
25.8
3
22.6
22.3
4
20.1
19.8
5
18.1
17.8
6
16.5
16.3
700
Band12/17
700
MHz
MHz
2
-6.0
-5.9
3
-9.5
-9.4
4
-12.0
-11.9
5
-14.0
-13.9
6
-15.5
-15.4
http://cellphonesignalbooster.us
Kit 311124-1180
• 1900 MHz Yagi Directional
• 80' RG11 Cable
• N-Male to F-Female adapter
Kit 314473-1175
• 75 Ohm Pole Mount
Panel Antenna
• 75' RG11 Cable
Kit 314475-1175
• 75 Ohm Wide
Band Directional
• 75' RG11 Cable
Signal 4G
470019
SMA
50 Ohms
Band13
800
MHz
10.0
Band13
800
MHz
38.4
40.6
Band13
800
MHz
24.1
Band13
800
MHz
-6.5
Band13
800
MHz
21.0
17.5
15.0
13.0
11.5
Band13
800
MHz
-5.7
-9.2
-11.7
-13.7
-15.2
5 dB nominal
> 40 dB
5.5 V 2 A
Kit 311141-1120
• 75 Ohm Grey Brick Antenna
• 20' RG11 Cable
1700/2100
1900
MHz
MHz
7.1
8.6
1700/2100
1900
MHz
MHz
81.8
75.4
85.4
77.4
1700
1900
MHz
MHz
25.6
25.0
2100
1900
MHz
MHz
-7.7
-5.8
1700
1900
MHz
MHz
21.3
21.9
17.8
18.4
15.3
15.9
13.4
13.9
11.8
12.3
2100
1900
MHz
MHz
-6.8
-6.0
-10.3
-9.5
-12.8
-12.0
-14.7
-14.0
-16.3
-15.5
7
Publicité
Chapitres
Table des Matières
