Signal Booster Specifications - weBoost Connect 3G Instructions D'installation

Signal Booster Specifications

Model Number
Connectors
Antenna Impedance
Frequency
Passband Gain (nominal)
20 dB Bandwidth (MHz)
Power output for single cell phone (dBm)
Power output for multiple received channels
(Uplink) dBm
Power output for multiple received channels
(Downlink) dBm
Noise Figure (typical downlink/uplink)
Isolation
Power Requirements
The Manufacturer's rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the rating
would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users. This power
reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.
!
To Outside
Antenna
Lightning
Surge Protector
(sold separately)
Ground Wire
(not included)
To Signal Booster
Need help?
Typical
Maximum
Uplink
Downlink
No. Tones
2
3
4
5
6
No. Tones
2
3
4
5
6
RECOMMENDED: INSTALLING THE LIGHTNING SURGE PROTECTOR
(SOLD SEPARATELY)
INSTALL THE LIGHTNING SURGE PROTECTOR (LSP) CLOSE TO THE SIGNAL
BOOSTER. ATTACH THE CABLE FROM THE OUTSIDE ANTENNA TO THE
SURGE PROTECTOR. ENSURE THE LSP IS PROPERLY GROUNDED.
#859992-75 OHM MAY BE PURCHASED AT WWW.WEBOOST.COM OR BY
CALLING 800-204-4104.
www.weBoost.com
Connect 3G
™
472005
F-Female
50 Ohms
824-894 MHz / 1850-1990 MHz
800 MHz
Band 5
60.3
800 MHz
Band 5
40.8
41.1
800 MHz
Band 5
24.9
-2.2
800 MHz
Band 5
24.8
21.3
18.8
16.9
15.3
800 MHz
Band 5
1.3
-2.2
-4.7
-6.6
-8.2
3 dB nominal / 6 dB nominal
> 90 dB
AC / DC 6V, 2.5A, w/2.5x5.5mm Jack
Customer Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm
1900 MHz
Band 2
60.4
1900 MHz
Band 2
74.7
75.0
1900 MHz
Band 2
22.5
-2.1
1900 MHz
Band 2
20.2
16.7
14.2
12.3
10.7
1900 MHz
Band 2
3.5
-0.1
-2.6
-4.5
-6.1
11