Cardin Elettronica RCQ-3G/WF Mise En Service Et Utilisation page 21

Cancelling a channel using a transmitter
• Scroll to menu "2) CANCEL TX", press
• Press the channel on the transmitter you wish to cancel, "Activation 2" will appear on the LCD display;
• Press the channel a second time (same TX, same channel), "SEARCHING....." will appear on the
display followed by one of the following:
- the symbol '-' means the channel has been cancelled.
- means that the channel is not present in memory.
NON TROVATO!
Cancelling one or more channels by means of memory position:
• Scroll to menu "3) CANCEL POS.", press
an arrow key
the chosen position will appear on the LCD display (e.g. A B _ D).
• Using the
keys move the cursor to the desired channel, press
the letter. Repeat the procedure for all the channels you wish to cancel.
• Move the cursor to OK and press
with the asterisk symbol
Note:
(3)
If the chosen location is free 'FREE!' will appear on the display
(4) If you cancel all the activated channels the transmitter will have been eliminated from the system and
"ELIMINATED!" will appear on the display.
Cancelling the entire memory content:
• Scroll to menu 4) CANCEL MEM., press
and hold down the
appear on the display for several seconds.
At this point the entire memory content has been cancelled and the receiver has been reset to factory
settings.
Transmitter information
When the receiver detects the activation of a transmitter it proceeds to activate the relay that corresponds
to the channel that has been received.
The following information appears on the LCD screen:
"CH": the transmitter channel is already memorised - "P" : memory location
"SN": transmitter identification code - "A" : Channel received then activated
This information remains on the display for a maximum of four seconds.
Memorizing more transmitters by using a previously memorised transmitter
This procedure allows you to enable a new transmitter (from a remote position) with the help of a transmitter
that has already been memorised in the system.
As the presence of the receiver is not required this procedure can be carried out in any remote location (for
example in your chosen sales outlet).
• The 'rapid memorization function' will either be enabled or disabled according to the value set in the
"PPT" parameter: as follows:
- begin the normal radio control memorization procedure; the indication "ACTIVATION 1..." should
appear on the display;
- to enable the function, press and hold down the
- to disable the function, press and hold down the
- after four seconds an indication will appear on the display specifying the status of the function "PPT
ENABLE" if it is enabled or "PPT DISABLE" if it is disabled;
- the completion of the operations using the 'rapid memorization function' will be confirmed by the symbol
*
' ' appearing on the display preceded by the letter pertaining to the activated channel (only valid for
the first activation);
ENT
ENT
to scroll to the location you wish to cancel, press
. "WAIT....." will appear on the display and the channels marked
ENT
*
will be cancelled
ENT
key for four seconds, the indication "CANCELLING" plus a progress bar will
and "Activation 1" will appear on the LCD display;
and "Location 1" will appear on the LCD display, press
(4) .
and "CONFIRM?" will appear on the LCD display, press
key;
key;
21
(3)
, the channels present in
ENT
*
and the symbol
ENT
will replace