Philips RQ1100 Serie Manuel page 19

3 Simultaneously press the release buttons on
both sides of the cleaning chamber (1). Then lift
the Jet Clean System off the cleaning chamber
(2).
, The cleaning chamber remains behind.
4 Fill the cleaning chamber with HQ200 cleaning
fluid to a level between the two lines.
5 Place the Jet Clean System back onto the
cleaning chamber.
Make sure the release buttons click back into place.
Using the Jet Clean system
Note: If you use the shaver with shaving foam or
shaving gel, we advise you to rinse it under the hot tap
before you clean it in the Jet Clean System. This
guarantees an optimal lifetime for the cleaning fluid.
1 Hold the shaver upside down above the holder
with the back of the shaver pointing towards
the holder.
2 Place the shaver body in the holder behind the
two clips (1) and press it down until it locks
into place (2).
, The display shows that the shaver is charging
(see chapter 'The display').
English
19