THOMSON WEAR7701 Mode D'emploi page 6

5. Charging
Fully charge the earphones and the charging box once before using them for the rst time
1
Insert the earphones and connect the charging box
Place the earphones in the charging box Ensure that the earphones are inserted into the correct
sides, using the L/R markings as a guide
Connect the USB charging cable included to the charging socket (7) on the charging box
Connect the free plug on the micro-USB charging cable to a suitable USB charger To do this,
consult the operating instructions for the USB charger you are using
Micro-USB
2
Charging procedure for the charging box and earphones
The status LED on the charging box (2) lights up solid red during the charging process Once the
charging box is fully charged, the charging box LED (2) goes green
The status LEDs on the earphones (3) light up solid red during the charging process Once the
earphones are fully charged, the status LEDs (3) light up green for around 30 seconds and then the
status LEDs go out
It can take up to 2 5 hours (earphones) or up to 3 5 hours (charging box) until the batteries are
fully charged
CHARGING
3 Battery capacity
Charging box
When battery levels are low (< 10%), the status LED (2) ashes red
Earphones
When battery levels are low, the status LED (3) ashes red
The actual battery life will vary depending on how you use the device, the settings and the ambient
temperatures (rechargeable batteries have a limited life)
Note
If you have not used the device for a few months, it can take up to 15 - 30 minutes until the
status LED (2/3) lights up red during the charging process
3
:30
h m
2
:30
h m
CHARGED
4