Epson ELPDC06 Guide De L'utilisateur page 21

"Reset"
"Save as"
"Save"
Appendix
Solving Problems
Problem
No image appears
The image is out of focus
Problems with the ArcSoft Application software for
ELPDC06
Error message
The connection to your camera
was lost.
The camera is not found. The
camera is in use by another
program or is not connected.
Make sure that the camera is
connected and working
properly, then try again.
The camera is not found or is
not working properly.
Please click Connect button
and try again.
Editing bar
Capture
Resets the edited image.
Saves the edited image using a new name.
Saves the edited image by overwriting the existing image.
Solution
Check that the USB cable is connected properly and that the
power indicator is on.
Make sure that the document (subject of the image) is not too
close to the camera lens.
The auto focus may not be able to focus in the following
situations:
v Subject matter has low contrast between light and dark
areas
v Subject matter has repeated detailed patterns, such as
horizontal stripes and checkered patterns
v Image is dark overall
v Subject matter has a bright background
Solution
Make sure that the USB cable is connected securely, and
then click the
If a webcam or device other than the unit is connected,
disconnect it.
Make sure that the USB cable is connected securely, and
then click the
Adjusts the length of the recorded moving
image.
Captures a moving image.
button again.
button again.
21