Nyne NH-6500 Manuel Utilisateur page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

When you unplug the power cord,
always hold the plug instead of the
cord.
Do not overload power strips and
extension cords. Overloading can
The wall socket should be located
near the device and be easily
accessible.
Where the mains plug or an appliance
coupler is used as the disconnect
device, the disconnect device shall
remain readily operable.
During lightning storms or when the
device is not to be used for a long
period of time, always unplug the
power cord of the device. Pulling on
the power cord can damage the wires
electric shock.
Do not attempt to repair or service the
device yourself. Opening or removing
the cabinet may expose you to
electric shock, and other hazards. If
repair is required, contact your dealer
service personnel.
Do not use the device if any
abnormality occurs. If any smoke or
odor becomes apparent, unplug the
power cord and contact your dealer
immediately. Do not try to repair the
device yourself.
Avoid using dropped or damaged
appliances. If the device is dropped
and the housing is damaged, the
internal components may not function
normally. Unplug the power cord
immediately and contact your dealer
for repair. Continued use of the device
Before moving the device, make sure
to disconnect the power cord and any
NYNE NH-6500_User Manual_A5.indb 5
To reduce the risk of electric shock,
do not touch any connector with wet
hands.
Use only with the cart
stand, tripod bracket,
the manufacture, or sold with the
apparatus. When a cart is used,
use caution when moving the cart/
apparatus combination to avoid injury
from tip-over.
Never remove the housing of the
device.
Never lubricate any part of the device.
Never place the device on top of any
other electrical equipment.
The CD player of this device produces
invisible laser beam, which may cause
hazardous radiation exposure.
Caution on battery usage:
To avoid battery leakage that may
result in bodily injury or damage to the
device:
Install batteries with correct
polarity, + and – in the battery
compartment of the device.
Do not mix new and old batteries,
or different types of batteries.
Follow the local regulations to
dispose of drained batteries.
Remove batteries if the device is
always connected to mains power
during use, or the device is not to
be used for a long period of time.
Never expose batteries to heat
sources, such as direct sunshine or
Never expose batteries to damp
environment to avoid short-circuit
or damage to the device.
EN
5
5/19/2012 6:13:17 PM

Publicité

Table des Matières
loading

Table des Matières