Connect The Antennas - Nyne NH-6500 Manuel Utilisateur

5
Insert four cross tapping screws
recessed screw holes in the larger
wooden board, and then tighten
them with an appropriate cross
screwdriver.
6
Align the smaller wooden board
with the hole at the bottom of
the device. Insert the cross screw
then tighten it with an appropriate
230mm).
7
Erect the device with the support
of the base stand.

Connect the antennas

Connect the AM loop antenna
NYNE NH-6500_User Manual_A5.indb 15
1
Assemble the supplied AM
antenna, and then strip off plastic
from the wire connectors.
2
Connect the supplied AM loop
antenna to the
on the back of the device.
Connect the FM antenna
Connect the supplied FM antenna to
the socket on the back of the
device.
sockets
EN 15
5/19/2012 6:13:25 PM