Beko KG530 Manuel D'utilisation page 23

• The thermostat is set to a very cool tem-
perature. >>> Set the thermostat to an
appropriate temperature.
Compressor is not working.
• In case of sudden power failure or pulling
the power plug off and putting back on,
the gas pressure in the product's cooling
system is not balanced, which triggers the
compressor thermic safeguard. The
product will restart after approximately 6
minutes. If the product does not restart
after this period, contact the service.
• Defrosting is active. >>> This is normal for
a fully-automatic defrosting product. The
defrosting is carried out periodically.
• The product is not plugged in. >>> Make
sure the power cord is plugged in.
• The temperature setting is incorrect. >>>
Select the appropriate temperature set-
ting.
• The power is out. >>> The product will
continue to operate normally once the
power is restored.
The refrigerator's operating noise is in-
creasing while in use.
• The product's operating performance may
vary depending on the ambient temperat-
ure variations. This is normal and not a
malfunction.
The refrigerator runs too often or for too
long.
• The new product may be larger than the
previous one. Larger products will run for
longer periods.
• The room temperature may be high. >>>
The product will normally run for long peri-
ods in higher room temperature.
• The product may have been recently
plugged in or a new food item is placed in-
side. >>> The product will take longer to
reach the set temperature when recently
plugged in or a new food item is placed in-
side. This is normal.
• Large quantities of hot food may have
been recently placed into the product.
>>> Do not place hot food into the
product.
• The doors were opened frequently or kept
open for long periods. >>> The warm air
moving inside will cause the product to run
longer. Do not open the doors too fre-
quently.
• The freezer or cooler door may be ajar.
>>> Check that the doors are fully closed.
• The product may be set to a temperature
that is too low. >>> Set the temperature to
a higher degree and wait for the product
to reach the adjusted temperature.
• The cooler or freezer door washer may be
dirty, worn out, broken or not properly
settled. >>> Clean or replace the gasket.
Damaged / torn door washer will cause
the product to run for longer periods to
preserve the current temperature.
The freezer temperature is very low, but
the cooler temperature is adequate.
• The freezer compartment temperature is
set to a very low degree. >>> Set the
freezer compartment temperature to a
higher degree and check again.
The cooler temperature is very low, but
the freezer temperature is adequate.
• The cooler compartment temperature is
set to a very low degree. >>> Set the
cooler compartment temperature to a
higher degree and check again.
The food items kept in cooler compart-
ment drawers are frozen.
• The cooler compartment temperature is
set to a very low degree. >>> Set the
cooler compartment temperature to a
higher degree and check again.
The temperature in the cooler or the
freezer is too high.
• The cooler compartment temperature is
set to a very high degree. >>> Temperat-
ure setting of the cooler compartment has
an effect on the temperature in the freezer
compartment. Wait until the temperature
of relevant parts reach the sufficient level
by changing the temperature of cooler or
freezer compartments.
• The doors were opened frequently or kept
open for long periods. >>> Do not open
the doors too frequently.
EN / 23
EN
FR
DE
IT