Omnifilter OM26K Manuel page 5

EQUIPMENT INSTALLATION continued
Things You Need to Know
• When the controller is first plugged in, it may display
an Err 3, this means that the controller is rotating the
camshaft to the home position .
• The preset default time of recharge is 2:00 AM .
• The controller is programmed to recharge if a recharge
has not taken place in the last 7 days. This setting cannot
be changed .
• Make sure control power source is plugged in. The
transformer should be connected to a non-switched
power source .
• Unless changed, the settings for a newly installed system
are:
Hardness - 25 grains per gallon
Salt Setting - HC (High Capacity)
Internal System clock starts at 0 hours (midnight)
The first recharge will occur when the system clock
reaches 2:00 AM
• Test your water. Take a 4-5 oz sample of your water to
someone who can test for hardness . This information will
be used to setup the control .
OM26K SE10 • 5