Publicité
Réglementation
du Canada
This digital apparatus
does not exceed the Class B limits for radio noise
emissions
from digital
apparatus
as set out in the interference-causing
equipment
standard
entitled
"Digital
Apparatus,"
ICES-003 of the Industry
and Science Canada.
Cet appareil numérique
respecte les limites
de bruits radioélectriques
applicables
aux appareils numériques
de Classe B prescrites dans la norme
sur le matériel
brouilleur:
"Appareils
Numériques,"
NMB-003
édictée par
l' Industrie
et Sciences Canada.
Réglementation
du Royaume-uni
"This equipment
is approved
under approval
number NS/G/23/J/100003
for indirect
connection
to public telecommunîcation
systems in the Urûted
Kingdom,
i.e. when connected to the correct interface of a type approved
apparatus
in accordance with the instructions
for use of that apparatus.
If you are uncertain
about the connection
arrangement,
seek the help of a
qualified
engineer."
Réglementation
FCC
This equipment
has been tested and found to comply
with the limits for a
Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits
are designed to provide
reasonable protection
against harmful
înterference
in a residential
installation.
Thîs equïpment
generates, uses and cari radiate
radio frequency
energy and, if not installed
and used in accordance with
the instructions,
may cause harmful
înterference
to radio communications.
However,
there is no guarantee that interference
Will not occur in a
particular
installation.
If this equipment
does cause harmful
interference
ta
radio or television
reception,
which cari be determined
by turning
the
equipment
off and on, the user is encouraged
to try to correct the
interference
by one or more of the following
measures:
II
Reorient or relocate the receiving
antenna.
u
Increase the separation
beisz"een the equipment
and receiver.
Li
Connect the equipment
into an outlet on a circuit different
from that to
which the receiver is connected.
u
Consult the dealer or an experienced
radio/TV
technîcian for help.
Do not make any changes or modifications
to the equîpment
unless
otherwise
specbed
in the manual.
If such changes or modifications
should
be made, you could be required
to stop operation
of the equipment.
Use of shielded
table is required
to comply
with Glass B limits in Subpart B
of Part 13 of FCC Rules.
. . .
ZZZ
Publicité
