Publicité
Les langues disponibles
Les langues disponibles
METER DESCRIPTION
„ Front Panel Description
1. Battery compartment cap
2. LCD display
3. MODE button
4. CAL button
5. ON/OFF button
6. Electrode collar
7. Electrode
(Note: The Electrode cap is not shown)
„ TRACER DISPLAY
1. Bar graph reading
2. Bar graph scale designations
3. Units of measure
4. Calibration indicators
5.
and
RENEW
CAL
6. Measurement reading
7.
(low battery)
BAT
(data hold) indicators
HOLD
8. Temperature display
BASIC OPERATION
„ Powering the TRACER
If the batteries are weak, the
ON/OFF button to turn the TRACER on or off. The auto power off feature will
shut the TRACER off automatically after 10 minutes of inactivity.
„ Automatic Electrode Recognition
When the TRACER is turned on, it will recognize the type of electrode that is
connected and will display the appropriate unit of measure. An electrode must
be attached before turning the meter on.
„ Changing the Displayed Temperature Units
Press and hold the CAL button for approximately 3 seconds. The
will change first and the numerical temperature value will change only after the
button is released. NOTE: If the calibration mode is accidentally accessed and
appears on the display, turn the TRACER off and begin again.
CAL
„ Data Hold
Press the MODE button to freeze the current reading. The
appear along with the held reading. The held reading will be stored in memory.
Press the MODE button to return to normal operation.
1
2
indicators
3
4
5
indicator will appear on the display. Press the
BAT
7.0
500
12
2.0
0
1000
ppm
pH
mv
10.04
BAT HOLD
4
7
10
78.6
°C
RENEW
CAL
°F
3
6
and
7
8
or
icon
°C
°F
display icon will
HOLD
Publicité
