System Disabling; Disabling By The Front Panel Key; Disabling By Other Command System - Hiltron PROTEC3 Mode D'emploi

PROTEC3 - User's manual
4.3

System disabling

4.3.1 Disabling by the front panel key switch
Open the entering door.
The yellow LED "ALARM"
The alarm will not activates immediately becouse the entering door is usually protected by
the delayed zone 1: the entering time will allows to reach the central unit to disable the
system.
Turn the key switch
The yellow LED "ALARM"
4.3.2

Disabling by other command system

If an electronic key system, a proximity key system, or an electronic keypad system is
installed outside of the protected areas, it's necessary to leave the key switch
"ON" position.
All the SKI connector for the electronic
key, the PXR reader for the proximity key
and the KBC, KBM and KBT keypads have
two LEDs, one green and one red,
indicating the central unit status (see table
beside).
To disable the system:
Verify that the red LED is turned off.
If it's blinking, it means that an alarm
was happened, precisely on the zone
signalled in the central unit with the
LED "MEMORY ALARM" blinking.
Insert the electronic key, or approach
the proximity key to the reader, or digit
the code on the keypad.
The green LED turns on indicating that
the system is disabled.
30
is lit.
7
in the "ST/BY" position.
1
turns off indicating that the system is disabled.
7
GREEN
LED
ON
GREEN
System
disabled
LED
RED
Opened
zone/s
LED
BOTH
ALWAYS in the
1
RED
LED
FLASH OFF
System System
disabled enabled
Alarm Closed
memory zones
Exiting
time