Installation; General Instructions; Power Supply - Hiltron PROTEC3 Mode D'emploi

2

Installation

2.1

General instructions

Do not install the device at places exposed to the bad weather or to the extreme
temperatures.
The central unit is protected from the opening, but the installation in a safe place is a
greater protection of the device.
For a strong and safe fixing, it needs making sure the wall surface is plane.
Fixing the device by the four fishers included in the central unit and no replacing them with
others of more small size.
Fixing the central unit at a height that allows an easy access to the frontal panel.
2.2

Power supply

It 's important to know that the entire system is powered exclusively by the 12V 7,5Ah lead
battery inside of the burglary central unit; the lead battery is constantly in charge by the AL5
power supplier/battery connected to the 230V~ main power supply.
WARNING!
The main power supply 230V~ has to be connected to the power supplier/battery
charger AL5 by two 1,5mm² double-isolation wires coming from a sectioning switch(i.e.
a magneto-thermic protection switch) used exclusively for the burglary central unit.
Inside of the central unit positioning orderly the two wires, locking them by wrappers.
Installation
Switch
230V~
50Hz
main power supply
21