Publicité
Les langues disponibles
Les langues disponibles
MODEL:
Authorized KICKER Dealer:
Purchase Date:
Model Number:
Serial Number:
PERFORMANCE
Model:
RMS Power
@ 14.4V, 4Ω mono, 1% THD+N
@ 14.4V, 2Ω mono, 1% THD+N
Length, in. (cm)
Electronic Crossover
Subsonic Filter
Bass Boost
Specifi cations common to all models:
Height, in. (mm)
Width, in. (mm)
Frequency Response ± 1dB
Signal-to-noise Ratio
Input Sensitivity
Remote Bass
Pro Tip: To get the best performance from your new KICKER Amplifi er and extend the warranty by 1 year, use
genuine KICKER accessories and wiring.
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4" (10cm) of open
ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger compartment. Drill
four holes using a 7/64" (3mm) bit and use the supplied #8 screws to mount the amplifi er.
Wiring: Disconnect the vehicle's battery to avoid an electrical short. Then, connect the ground wire to the
amplifi er. Make the ground wire short, 24" (60cm) or less, and connect it to a paint-and-corrosion-free, solid,
metal area of the vehicle's chassis. Adding an additional ground wire of this same gauge (or larger) between the
battery's negative post and the vehicle chassis is recommended.
2
2011 DX Mono Amps RevI.indd 2
2011 DX Mono Amps RevI.indd 2
DX.1-SERIES AMPLIFIERS
OWNER'S MANUAL
DX250.1 / DX500.1 / DX1000.1
DX250.1
DX500.1
140 x 1
275W x 1
250 x 1
500W x 1
10-1/4" (26)
10-1/4" (26)
Fixed, 80Hz
Variable lo-pass 50Hz–200Hz
24dB/octave
18dB/octave
Fixed, 25Hz
Variable hi-pass 10Hz-30Hz
24dB/octave
18dB/octave
Selectable, 0/9dB
Variable 0–12dB @ 40Hz
@ 40Hz
2-1/4" (57)
8-5/16" (211)
20Hz–200Hz
>95dB, A-weighted, re: rated power
Low Level: 125mV–5V
High Level: 250mV–10V
Yes (not included)
Yes
DX1000.1
550W x 1
1000W x 1
10-1/4" (26)
Yes
11/3/2010 1:29:25 PM
11/3/2010 1:29:25 PM
Publicité
