To Assemble The Product; Operation; To Do Before You Use The Product For The First Time; To Connect A Gas Cylinder To The Product - Burns & Barkles 010376 Instructions D'utilisation

● Do not use water to control or extinguish the flames.
● Let the product become cool before you clean it or do maintenance
on it.
● Let the product become cool before you put it in storage.
● Keep the product in a dry and closed storage, away from children,
when the product is not in operation.
● Empty and clean the drip tray regularly.
● Clean the grease tray before each use.
● Clean the product regularly.
3 Assembly

3.1 To assemble the product

● Assemble the product on a level surface. (Figure 1-14)

4 Operation

4.1 To do before you use the product for the first
time
1
Remove all packaging and stickers.
Warning! Risk of fire. Packaging and stickers are flammable. Make
sure that all packaging is removed before you use the product.
2
Connect a gas cylinder (not included) to the product. Refer to "4.2 To
connect a gas cylinder to the product" on page 16.

4.2 To connect a gas cylinder to the product

Warning! Do not connect or replace gas cylinders near sources of
heat or naked flames.
Warning! Do not smoke when you connect or replace gas
cylinders.
Caution! If you keep the product outdoors, keep the regulators
away from precipitation.
1
Make sure that the gas cylinder complies with the applicable national
regulations and the specifications in technical data. Refer to "9
Technical data" on page 17.
2
Put the product on a stable and level surface and make sure that the
product is cool.
3
Connect an applicable gas regulator (not included) to the valve on
the gas cylinder (not included) and tighten it fully with a wrench.
Warning! The regulator must comply with EN 16129 and applicable
national regulations.
4
Put the gas cylinder on the left side of the product, away from heat
and hot surfaces.
5
Connect the hose to the regulator on the gas cylinder.
Note! The hose diameter must be 8–10 mm and must not be longer
than 1.5 m.
6
Connect the hose to the product (A). Make sure that the hose is not
twisted or pinched when you connect it. (Figure 14)
16
7
Connect the hose (B) to the valve for the side burner and to the
control knob for the side burner.
8
Examine all hoses and connections for damage and leakage before
you use the product. Replace damaged or defective hoses.
Warning! Immediately close the gas valve on the gas cylinder if
there is leakage.
Warning! Do not use a naked flame to check for leakage.

4.3 To use the product

Warning! Always have a BC type of fire extinguisher ready when
you operate the product. Do not use water to extinguish fires.
Warning! If a grease fire develops, turn all control knobs to the
"OFF" position, close the gas valve on the gas cylinder fully, and close
the lid. Grease fires will not be extinguished If you just close the lid.
Caution! Do not use plastic or glass utensils with the product.
Only use accessories recommended by the manufacturer of the
product.
1
Put the product on a stable, level, and heat-resistant surface and
press down the locks on the wheels.
Warning! Always have a BC type of fire extinguisher ready when
you operate the product. Do not use water to extinguish fires.
2
Open the gas valve on the gas cylinder.
3
Turn the control knobs to the required heat setting and cook the food.
4
When you have finished cooking the food items, turn all control knobs
to the "OFF" position and close the gas valve on the gas cylinder fully.
Let the product become cool.
5
Clean the product. Refer to "5.1 To clean the product" on page 16.

5 Maintenance

5.1 To clean the product

● Clean the product regularly to prevent grease fires.
● Turn the control knobs to the "HIGH" to burn off food scraps.

5.2 To do maintenance on the product

Warning! Let the product become cool before you do
maintenance.
● Let an authorized service center do a check of the product 1 time per
year.
● Do a check of all hoses at least 1 time per year and every time you
replace the gas cylinder.
Warning! Always replace damaged hoses with new hoses that
have the same quality and length.
● Replace all hoses every 2 years. Follow national regulations for
replacement of hoses.
2022_001