Peavey PV 10 Guide Des Opérations page 9

Signal LED (11)
The signal LED lights when the channel level reaches approximately -20 dBu. This not only indicates which
channels are active, but also serves as a mini level meter.
Fader (12)
The channel fader is the channel output control and sets the signal level to the left and right mix and the effects
send control. The optimum setting is the 0 (unity gain) position.
Tape In/Out (13 & 14)
The tape input jacks are designed to accommodate tape‚ CD or
computer sound card output levels. The output level is +4 dBu for
connecting to a recorder or sound card input. The tape inputs can
be used as an additional stereo input by engaging the Tape to Main
Mix switch (27). The tape input can also be used to monitor the
recorder/sound card output without the risk of feedback.
EFX Select (15)
This rotary switch selects one of sixteen available effects. See the
table below for descriptions of each.
Effect
1
Hall Rev
2
Large Hall Rev
3
Room 1 Rev
4
Room 2 Rev
5
Plate 1 Rev
6 Plate 2 Rev
7 Cathedral
8 Spring
9 Delay 1
10 Delay 2
11 Delay 3
12 Tape Delay
13 Doubler
14 Shimmer
15 Vocal Enhancement 1
16 Vocal Enhancement 2
EFX Time (16)
This control adjusts the time of the particular reverb or delay.
Description
Medium Concert Hall
Larger Concert Hall Darker
Intimate Room Bright
Larger Room Darker
Bright
Darker
Large Space, Long and Darker
Classic Spring
Single Delay (Slap-back)
Warm Delay with Repeats
Dark Delay with Repeats
Warm Delay
Single Delay, 30 - 120 ms
Warm Delay with Modulation
Brightens and adds Room Reverb
Brightens and adds Spring Reverb
18
17
Application
Ensemble
Gen Reverb
Pop Vocal
Drums, Rhythm
Pop Vocal
Drums
Choir
Guitar
Voc/Instr
Instruments
Instruments
Instruments
Instruments
Instruments
Vocals
Vocals
9
13 14
15
16
Parameter
Rev Time
Rev Time
Rev Time
Rev Time
Rev Time
Rev Time
Rev Time
Rev Time
Dly Time
Dly Time
Dly Time
Dly Time/Feedback
Dly Time
Dly Time
Rev Level
Rev Level