Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.5a. In case of clogged nozzle
Do not use metal instruments. Use a brush with nylon bristles and liquid deter-
gent.
5.6. Cylinder maintenance
• Remove the pumping rod from the chamber. Loosen the gasket holder and
remove the assembly;
• Remove the chamber (A) from the cylinder (B). Clean the ball (C) and the piston
cup (D); replace them if necessary.
A
D
5.7. Triple rinse of empty agrochemicals containers
NOTICE: Even containers that are considered empty still contain chemical resi-
dues. Therefore, discarding the containers without washing out the residues is
extremely dangerous to man, animals and environment. In the case of metal, plas-
tic and glass chemical containers, each container must be rinsed three times to
ensure the residues are completely removed. This manual describes how to make
the triple rinse in a correct, safe and effective way.
1.
Immediately after emptying the container, you must keep it with the
opening upside down over the sprayer tank opening or over the bucket
that you are using to prepare the chemical mixture for at least 30 seconds,
until no residue is left in the container, when the drops are falling in long
intervals.
2.
Hold the container in the upright position and fill with water up to 1/4. For
example: in a 1000 ml container, put 250 ml of water.
3.
Install the container cap and tight it enough to avoid leakage during the
agitation.
4.
Agitate the container strongly in all ways (horizontal and vertical), for ap-
proximately 30 seconds to remove the residues that are on the container
internal walls.
5.
Take the container cap off and carefully pour the rinse water into the spray
tank.
6.
Keep holding the container over the spray tank opening for approximate-
ly 30 seconds to the last drop.
7.
Repeat this operation twice more. This way, you complete the triple rinse.
8.
Make the plastic and metallic containers useless by piercing the container
bottom with a pointed instrument. This way, their labels are not damaged
for identification purposes.
Clean nozzles with brush
C
B
6. Statement of Limited Warranty
MÁQUINAS AGRÍCOLAS JACTO S.A. shall warrant the equipment described in this
manual and shall repair or replace parts and components which, under normal
operation and wear, in accordance with technical recommendations, show DE-
FECTS IN MATERIAL OR WORKMANSHIP, based on the following conditions.
WARRANTY PERIOD
• 03 (three) years from the date of sale to the original purchaser.
WARRANTY APPLICATION
• JACTO shall honour this warranty, free of charge, if any part or component
shows defect in MATERIAL OR WORKMANSHIP, after final analysis at the fac-
tory.
THIS WARRANTY SHALL BE NULL & VOID IN CASE OF:
• Misuse of the equipment against specifications in the OPERATOR'S MANUAL,
overwork or accidents.
• Preventive/remedial maintenance performed by unauthorized people.
• Use of parts and components not supplied by JACTO.
• Modification of the equipment or any characteristic of the original design.
THIS WARRANTY SHALL EXCLUDE:
• Parts which show wear and tear due to use, UNLESS THEY SHOW DEFECTS IN
WORKMANSHIP, ASSEMBLY OR MATERIAL.
• Damages resulting from accidents.
• Transportation or freight of the equipment, parts and components in case
such warranty is not approved.
• Transportation and mobilization of technicians.
GENERAL INFORMATION:
• Parts replaced within the warranty period shall be property of JACTO.
• The warranty on replaced parts and components shall expire together with
the equipment warranty period.
• Eventual delays in performing services shall not give the owner right either to
indemnity or to extension of the warranty period.
• JACTO reserves the right to modify its products or to interrupt the manufac-
ture without prior notice.
Publicité
Table des Matières
