Start Your Session - DJO Global Compex WIRELESS Mode D'emploi

4.4 START YOUR SESSION

SWITCH ON THE MODULES BEFORE STARTING THE STIMULATION SESSION
Before initiating the stimulation and mi-SCAN measurement, you have to turn on the modules one after
another by pressing their On/Off buttons. Once the 1st module is detected by the remote control, you can
switch on the 2nd module and so on up to the 4th module. If you only want to use two modules for your
session, just press the START button after the second module is detected.
Please note: For a session which is
optimally adapted to your muscles,
Compex recommends that you always
perform an mi-SCAN measurement
before starting a stimulation session (see
explanation below).
BEGINNING OF THE STIMULATION SESSION: MI-SCAN MEASUREMENT
This feature adapts the electrostimulation session to each individual user's physiology. Just before starting
your stimulation session, mi-SCAN probes the chosen muscle group and automatically adjusts the
stimulator parameters to the excitability of this area of the body. It is a truly personalized measurement. In
order to ensure that your session is as effective and comfortable as possible, it is highly recommended that
you perform the mi-SCAN at each session.
This function is implemented at the start of the programme by a short sequence during which
measurements are taken. You should remain completely still and be perfectly relaxed throughout the
measurement test. Once the test has been completed, the programme can start.
Start your session without
the mi-SCAN measurement
Start your session with the
mi-SCAN measurement (see
explanation below)
Back to previous screen
10