Publicité
Les langues disponibles
Les langues disponibles
Setting up the Tango
CAUTION
•
Be careful to place the device where it cannot be bumped, and where no one will
trip over the power cord.
•
If you put the device on the floor, make sure the area is free from dust and clear
of bedding, clothes or other objects that could block the air inlet.
•
Make sure the area around the device is dry and clean.
WARNING
•
Make sure the power cord and plug are in good condition and the equipment is
not damaged.
•
Only ResMed air tubing should be used with the device. A different type of air
tubing may alter the pressure you actually receive and reduce the effectiveness
of your treatment.
•
Blocking the hose and/or air inlet of the device while in operation could lead to
overheating of the device.
1
Connect the power cord to the rear of the Tango.
1.
Plug the other end into a power outlet.
2.
3.
Connect the air tubing to the air outlet of the Tango.
4.
Connect the assembled mask system to the free end of the air tubing.
2
3
3
4
Publicité
