GreenWorks G40TL Manuel Opérateur page 5

WARNING
The tines and the machine may damage even if you move
the machine with the motor switched off. To prevent the
tines from touching the ground while moving please tilt the
machine.
3.1.4 INSTALL THE BATTERY PACK
Figure 5.
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Open the battery door.
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
3.1.5 REMOVE THE BATTERY PACK
Figure 5.
1. Open the battery door.
2. Push and hold the battery release button.
3. Remove the battery pack from the machine.
4 APPLICATIONS
• Breaking up garden soil to prepare seed bed for planting.
• Shallow cultivating to remove weeds.
4.1 START THE MACHINE
Figure 4.
1. Press the safety lock button.
2. Pull the bail switch toward the handle while you hold the
safety lock button.
3. Release the safety lock button.
WARNING
Hold the machine with two hands during operation.
Stand behind the machine with the tines on the ground and
the work area clean and free of obstructions.
NOTE
English
4.2 STOP THE MACHINE
Figure 4.
1. Release the bail switch to stop the machine.
4.3 NARROW CULTIVATING WIDTH
The two outer tine blades can be removed from the unit to
allow a more narrow cultivating width.
1. Remove the ring pins from the holes on the ends of the
tine shaft.
2. Remove the outside tines and felts from the tine shaft.
3. Place hitch pins in the holes.
4.4 OPERATION TIPS
The cultivator can be used to break up garden soil and
prepare a seedbed for planting. Plan ahead to leave enough
room between the seed rows to allow for machine cultivating
after the plants have grown.
1. Several passes over the same path may be required to
reach the desired depth. Do not try to dig too deeply in
the first pass.
2. If the machine jumps or bucks, allow the unit to move
forward at a slightly faster rate or install wheel assembly.
3. If the cultivator stays and digs in at one spot, try rocking
it from side to side in order to start it moving forward
again.
4. If the soil is very hard, water a few days before
cultivating. Avoid working the soil when soggy or wet.
Wait a day or two after heavy rain for the ground to dry.
5. Shallow cultivating less than 5cm. deep can be used to
disrupt weeds and aerate soil, without injuring nearby
plant roots. It should be done often so that weeds do not
grow large and cause tangling in the tines of the unit.
5 MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
5
CAUTION
CAUTION
WARNING
EN