L-Door Efficiency 800 Manuel page 47

1. To move the garage door, manually pull on the pull cord (I) on the
carriage.
2. Disconnect the carriage from the toothed belt or the chain.
3. The garage door can now be moved manually.
4. To operate the gate manually for a longer period of time, you can
insert the locking pin (II) into the carriage (III) in the bore provided
for this purpose. To restore normal operation, loosen the locking
pin (II).
Warning:
By using the quick release uncontrolled movements of the garage door are possible.
The garage door may be out of balance or the springs might be broken or worn. Please consult your
dealer of manufacturer.
Note: When installing the system, locking elements of the garage door operator are dismantled. These should be
reinstalled if the garage door has to be controlled manually over a longer period of time. This way the garage door
can be locked when closed.
Open or close the garage door (other operation modes)
• Possible operating modes see section "Special settings".
W-800
47 | Manual / L-Door Efficiency 800
II
III
Operation
I
47