Actegy REVITIVE CIRCULATION BOOSTER Manuel De L'utilisateur page 10

EN
Instructions for use
f Remove the plastic liner from the Body Pads, by
peeling it off carefully. Replace the Body Pads onto
the plastic liner after use.
g Press the Body Pads on the area you wish to apply
electrical stimulation to, as shown on page16, gently
pressing the adhesive side against the skin.
h Press the power button on the Revitive.
You will hear a beep and the display lights will read
30 minutes.
To turn off the device at any time during
operation, press the power button.
R
i Press the
start stimulation.
Press the (+) button to increase the level.
Press the (–) button to decrease the level.
R
j
Ensure you familiarise yourself with the feeling of
Electrical Muscle Stimulation (EMS). Use on a low
intensity for 30 minutes once per day for a
few days.
18
4426_IFU04_18137108.indd 18-19 4426_IFU04_18137108.indd 18-19
(+) Intensity Control, one time, to
R
R
Set the intensity at a level you can feel the stimulation
or see your muscles twitch.
It is normal to feel tingling or varying sensations in
your muscles you are treating.
k After a few days of familiarisation, use a higher intensity
that provides you with strong but comfortable muscle
contractions.
You can set the intensity between 1-50.
Please note that the intensity required may vary from
day to day.
If you feel pain or discomfort:
• Lower the intensity of the Body Pads using the
Control.
• You can also choose to stop therapy before the end of the 30 minute
session to avoid skin irritation. You can do this by pressing the
power button.
l The Time display will start to count down in
minutes as Revitive cycles through its program.
m When Revitive times out, the
00 and you will hear three beeps, and the device will
switch itself off automatically.
EN
(–) Intensity
Time display reads
19
01/07/2021 15:04 01/07/2021 15:04