Inepro MicroTimer 2400 Manuel Technique page 34

Extra functioning (with all Ecos modules):
The MicroTimer® can be activated with three freely programmable time-segments. The duration of these time-segments
can be set at 0 to 255 minutes. The MicroTimer® starts with a prior time. During the prior time the length of the main time
will be shown intermittently on the display. During the prior time it is possible to reduce the main time if necessary. The
prior time can also be bypassed so that the main time will start automatically. During the main time the remaining time will
be shown on the display. When activating a pause a buzzer signal may be generated. Another possibility consists of the
automatic main time adjustment based on the progression of the service counter. The main time is automatically followed
by the post time. During the post time "Cl" (cool) is displayed. After the post time it is possible to activate a clean function,
in this case "CL" is displayed intermittently. This clean function inhibits the MicroTimer®. Furthermore, there is an "after
start" function by means of which an extra main time of 30 seconds can be given at the end of the whole session.
Registration facilities, as for example start, running time and service counters can also be used. The start and running time
counters may either be activated as counters, which can be reset, or as cumulative counter, which can not be reset.
Automatic representation of the Running time counter is affected by pressing the Stop key during 3 seconds. The service
counter generates a SR (service message) on the display.
26 - MicroTimer - 2400