Inepro MicroTimer 2400 Manuel Technique page 32

Standard functioning (without Ecos modules):
In the basic version during stand-by a point (.) will be shown on the display. As soon as the main time is connected the
display will change into two hyphens (--). The maximum period of time to be programmed in the MicroTimer® is 15
minutes. The main time starts after pressing the timer-key, after inserting a coin or by means of a continuous external
drive. The MicroTimer® output is programmable. It may be chosen between the standard "continue" output, which means
that both relays are activated during main time, and a "pulse" output, which means that a pulse is generated at the
beginning and the end of the main time. The operator may choose either to allow the creation of a pause during the main
time or not. If a pause is allowed, it can be created by pressing the Start/Pause key. The operator can also choose
between interrupting and continuing the main time during the pause mode.
24 - MicroTimer - 2400