Publicité
Les langues disponibles
Les langues disponibles
Figure 1: Alarm features
(1)
(2)
(3)
(1) LED
(2) Temperature sensor
(3) Test/Silence button
(4) Sounder vent
Mounting
Mounting hardware is included (screws and anchors), however
you may need different hardware depending on the installation.
To mount the smoke alarm:
1.
Remove the alarm. Turn the alarm counterclockwise
(about 15 degrees) and remove it from the base.
2.
Place the mounting base on the mounting surface at the
desired location and mark the mounting holes using a
pencil.
3.
Secure the mounting base to the surface.
4.
Attach the alarm. Align the tab on the alarm with the arrow
on the base, insert the alarm, and then turn it clockwise
(about 15 degrees) until it snaps into place. See Figure 3.
Figure 2: Battery compartment
(1)
(1) Battery compartment and cover
2 / 14
Figure 3: Aligning the alarm
(4)
(2)
(1) Alignment tab on alarm
(2) Alignment arrow on base
Sensor test
The system and sensor test verifies good communication
between the unit and receiver/panel. The sensor test should be
performed weekly.
To conduct a sensor test:
1.
Put the panel into Sensor Test mode (refer to the specific
panel installation instructions).
2.
Press and hold the Test/Silence button for 4 seconds. The
unit transmits a test signal.
Holding the Test/Silence button for 20 seconds will cause
the unit to send a signal through to a central station.
3.
Listen for the appropriate response from system sirens
(refer to the specific panel installation instructions).
4.
After testing all units, exit from Sensor Test mode.
Smoke test
The smoke test verifies that the unit activates when detecting
smoke, that the transmitted signal is received by the
receiver/panel, and that the panel reports the alarm to the
central monitoring station. The smoke test should be
performed annually.
Note:
To avoid false test results, wait 90 seconds after power-
up before conducting any testing.
To conduct a smoke test:
1.
Contact the central monitoring station to alert them that
you are testing the system and that they should not
dispatch authorities.
2.
Activate the unit using one of the following methods:
(1)
(2)
P/N 1061280-ML • REV B • ISS 25JUN12
Publicité
