Publicité
Les langues disponibles
Les langues disponibles
Positioning the convector
Â
Mount both support feet
onto the underside of the appliance (see fig. 5 on side 2).
Â
- Place the support feet
Â
- Fasten the feet
onto the convector with the screws provided.
- Plug it in.
á
The convector is now ready for operation.
The position of the rotary knob
0
- Heating is switched off
1
- Heating level 750 W
2
- Heating level 1250 W
MAX
- Heating level 2000 W
Ç
Function of the thermostat
Ç
The thermostat
switches the convector off and on automatically. If the temperature of the room falls
short of the required temperature, the convector switches on until the required temperature is reached.
f
- Lowest thermostat setting (frost protection level)
o o o
- Level independent adjustment range of the thermostat
MAX
- Highest temperature of the thermostat
T I P for adjusting the required room temperature
Ç
- Set the thermostat
to MAX.
á
The appliance begins to heat the room.
- As soon as the required temperature is reached, turn back the thermostat
thermostat switches off with an audible "click".
á
The required temperature will now be more or less maintained by the convector.
The fan (only for K 820)
For better dispersion of the air, you can turn on the fan with the fan switch
blown out of the air outlet grid
After use
Æ
- Turn the rotary knob
to the "0" position.
- If you do not intend to use the appliance for a while, unplug it.
Wall mounting (see figures 4, 6, 7 and 8 on side 2)
For wall-mounting, the support feet
Â
- Mount the support feet
observe the correct distances (figures 7 and 8). The dimensions of the required holes are shown
in figure 6.
- Push out the hooks on the support feet.
- Hang the convector on the support feet as shown in fig. 4.
Å
- Connect the plug
to the mains socket.
á
The convector is now ready for operation.
Permanent connection of the power supply
Ä
The connecting cable
can be permanently connected to the mains power supply. When doing this,
observe the wiring diagram and the illustrations starting from figure 9 on page 2.
C A U T I O N
• Observe the respective national requirements
•Permanent connection may only be carried out by a qualified electrician.
•Permanent connection may only be implemented to the mains if it is isolated (on all poles) at least
3 mm isolation for the contact opening is required.
• The appliance must be earthed.
on the bolts on the underside of the appliance.
Æ
Á
on the front side of the appliance.
Â
are used as wall mounting brackets.
on the wall with 4 pins Ø 6 x 30 mm and 4 screws Ø 5 x 30 mm. Please
Follow the safety notes described below
Ç
anti-clockwise until the
È
. Additional warmed air is
7
Publicité
