AKO K 810 Mode D'emploi page 6

C A U T I O N
• The convector is to be used exclusively for heating rooms. The appliance is designed for normal
domestic use and similar applications.
• If the convector is to be mounted on the wall, please make sure that the mains power socket is
freely accessible at all times and that the convector is not mounted directly underneath it.
• Do not use the appliance in rooms with bath, shower or swimming pool or in the vicinity of wash
basins or water connections (see fig. 8).
• Keep a distance of 30 cm free, all around the appliance. The appliance must not be covered up,
otherwise this could lead to over-heating which could result in a fire (see fig. 7).
• The appliance can get hot at the air outlet grid during operation.
• The appliance may not be operated by children.
• Never use inflammable cleaning agents, like petrol, for cleaning the appliance. Do not use the
appliance in rooms where combustible gases can be present.
• Make sure that no water or other fluids can enter into the appliance.
• Make sure that no objects can enter into the appliance.
• Unplug the appliance before cleaning.
• Occasionally check the power cable for damage. A damaged cable can cause dangerous electric
shocks. In case of damage, the cable must be replaced. This should only be done by an expert, as a
special tool is necessary.
• Check whether the voltage on the type label agrees with the voltage supply in your home.
• The appliance may only be opened up and repaired by qualified personnel.
Technical specifications
Convector
Nominal voltage
Power
Switched levels
Protection classe
Approx.dimensions
(W x H x D)
Approx. weight
CONSTRUCTION AND OPERATIONAL PARTS (see figures 1, 2 and 3 on page 2)
À
Air outlet grid
Á
Air outlet grid for fan (only for K 820)
Â
Support feet
Ã
Air intake grid
Ä
Connector cable
Your AKO convector
The AKO convector contains a powerful heating element. The heating power can be set to 750 W,
1250 W or 2000 W. The thermostat enables automatic temperature adjustment from frost protection to
around +35°C. The K 820 convector provides an additional fan.
After unpacking
- Check the appliance for visible damage.
á
If you should notice any damage, do not use the appliance. Please contact your dealer
immediately.
- Do not forget to unpack the support feet
- Please dispose of the packaging in an environmentally manner.
6
The following safety instructions should be observed
K 810
- 1 (OUT)
- 2 (750 W)
- 3 (1250 W)
- MAX (2000 W)
Thermostat with frost protection
function
70 cm x 45 cm x 15 cm
Â
. You will find them on the side of the packaging.
K 820
230V~ / 50 Hz
750 / 1250 / 2000 W
- 1 (OUT)
- 2 (750 W)
- 3 (1250 W)
- MAX (2000 W)
Thermostat with frost protection
function
- Fans
I
4,0 kg
Å
Mains plug
Æ
Rotary knob
Ç
Thermostat
È
Fan switch (only for K 820)