Hohner FOLDNAK M2 MINI Mode D'emploi page 11

Paper width
Position the left side guide (10) according to the paper format required using the
scale (2) and fix it with the knurled screw (1)
Insert paper squaring it up parallel to the left guide (10)
Shift the right side guide (11) closely to the inserted paper and fix it, leaving 1mm of
air. Important: The side guides (10, 11) must not catch on the movement of the
sheets.
Paper length
Open cover (5)
Adjust and fix the back stop (14) according to your paper format using the scale
Close cover (5)
Position of stapling heads
The BOOKLETMAKER FOLDNAK M2 is able to use four stapling positions with
up to four stapling heads (USA: 5 stapling positions with up to three stapling heads).
DIN-distances between the stapling heads are 50x80x50mm (USA: 2 1/8" on center).
Unlock the latch (15)
Take out stapling head, put it into a new position and lock the latch (15). The driver
blade's (16) hole needs to be hinged onto the pin (17), and the mark „26" on the
driver blade must show towards the rear side of the machine.
Bookletmaking or folding
Adjust guides (10, 11, 14) to paper format
Make sure, the knurled screw (19) and paper stop button (20) are pushed in
Insert paper making sure the sheets are squared up correctly
Push button „START" (6)
The stacker (4) can be used to stack a couple of booklets. If you only want to fold
paper without stapling then just remove the staples from the stapling heads.
BLOCK STAPLING
Adjust guides (10, 11) to paper format
Pull out knurled screw (19)
Unlock paper stop button (20) by slightly pushing it in
Insert paper making sure the sheets are squared up correctly
Push button „START" (6)
Remove the block manually
11