English - Hohner FOLDNAK M2 MINI Mode D'emploi

English

Congratulations for choosing to purchase the BOOKLETMAKER FOLDNAK M2.
It makes fast and easy works of producing impressing looking booklets. Even small
quantities become efficient to produce because adjustment requirements are minimal.
Components delivered
BOOKLETMAKER FOLDNAK M2 with two stapling heads, bag with two knurled
screws (1), 5.000 NAGEL-Staples 26/6, instructions manual.
Setup
Screw in the two knurled screws (1).
Please check the correct voltage setting (see switch at the back side of the machine).
Plug in the power cord.
Loading of staple magazine
Pull staple pusher (12) back until it locks on by itself
Open magazine cover (13)
Load staples
Close magazine cover (13)
Push staple pusher (12) gently down to unlock it and guide it towards the machine's
front side. Do not let the staple pusher snap forward because this would smash the
stick of staples.
You can use either of the three original NAGEL-Staple types 26/6 or Ri 26/6. We
recommend that you use the staple types as shown below:
Staple Type:
(Use only NAGEL staples as
other staples may damage the
stapling head or lead to bad
results.)
Booklets (2-15 sheets)
Loop Staple Flat Staple
Ri 26/6 26/6
x x
10