E-MORE 2M2S TQD Instructions De Montage page 14

ENGLISH
ADVANCED PROGRAMMING
1. Display units ( )
Change the numeric display to show height in either inches or centimeters.
Press button and hold for 3 seconds, handset displays
S
Press S button again to confirm the first programming setting.
It will display . Press
(cm)
After it display , press UP or DOWN. It will display
display current height (Inch)
2.Handset display brightness (
S
Press button and hold for 3 seconds, handset displays
Press UP/Down, it will display
S
Press to enter, it will display current brightness level
: Means normal brightness |
Press UP or DOWN to select the desired brightness level, press
height.
3. Setting voice ( )
S
Press button and hold 3 seconds, handset displays
Press UP or DOWN. It will display
S
Press button, it will display current sound status ,
: Means no voice when you press the button |
Press UP or DOWN to select
4. Go up anti-collision sensitivity (
The desk has an Anti-Collision Sensitivity that will stop the desk's movement if it hits something on the way up. You can
change this sensitivity level by doing the following:
S
Press button and hold for 3 seconds, handset displays
Press UP or DOWN. It will display
S
Press button to enter. It will display the current anti-collision sensitivity level. There are 9 levels for up from
to ;
is the most sensitive setting,
Press UP or Down to select the your favorite level. Press
display the current height.
5. Go down anti-collision sensitivity (
The desk has an Anti-Collision Sensitivity that will stop the desk's movement if it hits something on the way down. You can
change this sensitivity level by doing the following:
S
Press button and hold for 3 seconds, handset displays
Press UP or DOWN. It will display
S
Press button to enter. It will display the current anti-collision sensitivity level. There are 9 levels for down
From to ;
is the most sensitive setting |
Press UP or Down to select your favorite level. Press
6. Balance sensitivity (
The desk has a balance sensitivity to make sure the 2 columns always work in the same position . You can change this Sensi-
tivity level by doing the following:
S
Press button and hold for 3 seconds, handset display
.
Press UP or DOWN. It will display
S
Press button to enter. It will display the current balance sensitivity level. There are 9 levels for down from
is the most sensitive setting |
Press UP or Down to select your favourite level. Press
14
S
button to get CM display, wait 2 seconds, centimeters setting is done. It will display current height
)
.
: Means low brightness |
or , then press
)
.
is the least sensitive setting.
)
.
is the least sensitive setting.
)
.
is the least sensitive setting.
. Release button, press
S
S
, press button , wait 2 seconds, inches setting is done. It will
S
. Release button, press
: Means high brightness
S
button to confirm, wait 2 second. It will display the current
S
. Release button, press
or .
: Means with voice when you press the button.
S
to confirm, wait 2 seconds. It will display the current height.
S
. Release button, press
S
button to confirm, wait 2 seconds, it will
S
. Release button, press
S
button to confirm, wait 2 seconds, it will display the current height.
S
. Release button, press
S
button to confirm, wait 2 seconds. It will display the current height.
button to enter, it displays
S
S
button to enter, it displays
S
again to enter, it displays
S
again to enter, it displays
S
again to enter, it displays
S
button again to enter, it displays
.
.
.
.
.
to ;