E-MORE 2M2S TQD Instructions De Montage page 13

IMPORTANT SAVETY INSTRUCTIONS
Before using this device, read these operating instructions carefully and keep this user manual for future reference.
Before using the product, check the desk and power cables for any visible sign of damage. If you notice cuts and deep
scratches, do not turn on the device.
Before connecting the product to the power supply, make sure that the power supply voltage is compatible with the parame-
ters of the product.
Before using it, make sure that the length of the power cable allows you to connect the desk to the power supply.
The height-adjustable desk contains electronic circuits and shall only be used in dry environments. Do not use outdoors or in
very dusty environments. Keep away from heat sources and any corrosive materials.
Keep all electrical components away from liquids. Never touch or handle the desk, power supply, the control box, the panel
control, or any other cable with wet hands.
Clean the product only with a clean, dry, soft cloth or cloth. Disconnect from the power supply before moving or cleaning
electrical components.
Do not disassemble the columns, control box and control panel. These actions are considered damage caused by the user.
This product contains small parts. Make sure they are out of reach of children. Do not allow children to play with the device.
Packing materials must not be used as toy.
Do not lay or sit on the worktop. This product is not for lifting people.
Do not exceed the maximum permissible load weight.
This product can be used in a 10% cycle (2 minutes of operation, followed by 18 minutes pause).
The manufacturer cannot be held liable or responsable for any damage or injuries resulting from improper use of the height
adjustable desk, in other words, non-compliance with these safety instructions and warnings.
TROUBLESHOOTING
Error Code Possible Cause
E01, E02 Cables are not connected or broken
the weight of the desk exceeds 100/120 kg
E06 Lifting columns out of synch
E07 Loadweight exceeds 100/120 kg
E08 Input voltage lower than required
E09 Input voltage higher than allowed
Control panel is not connected or does not
E10
receive power
RES
Reset is required
Excessive use
HOT
E-MORE 2M2S / 2M3S TQD
How To Correct
Connect cables properly, if problem persists change engine
Remove weight from desk
Perform a reset as described under RES .
Remove weight from desk
Improve the input voltage
Lower the input voltage
Wait 1 second for the error code to disappear
If it persists check the connection cables
Hold the "Down"-Button for a while . The desk will lower to the
minimum height .
Do not use for 18 minutes . System will recover automatically .
13