AEG SRC 4438 Mode D'emploi page 41

First Use of the Device/Introduction
• Before the first use of the device, read the user manual
carefully!
• Select a proper place for the device such as a dry, and
even non slip area where you can easily operate the
device.
• Make sure the device is vented sufficiently!
• If still in place, remove the protection foil from the display.
Battery Installation
In case of power failure or a disconnection from mains
power supply the backup battery, if inserted, memorizes
the settings.
• Open the battery compartment at the bottom of the
device. Turn the lid towards the open lock icon ( ).
• Insert one button cell (CR 2032) in the battery com-
partment. Make sure the polarity is correct.
• Close the battery compartment. Turn the lid towards
the lock icon ( ).
Remove the battery during longer periods of non-use to
avoid battery leakage.
WARNING:
• Do not expose batteries to intense heat or direct
sunlight. Never throw batteries onto a fire. Danger
of explosion!
• Keep batteries out of the reach of children. They are
not toys.
• Do not force batteries open.
• Avoid contact with metallic objects. (Rings, nails,
screws etc.) Danger of short circuits!
• Short circuits may overheat or even ignite batteries.
This may lead to combustion.
• When transporting the batteries, cover the terminals
for your safety with an adhesive strip.
• If a battery leaks, do not rub the fluid into the eyes
or the skin. If acid comes into contact with the eyes,
rinse with purified water and seek medical advice if
symptoms persist.
CAUTION:
Do not dispose of batteries with household waste. Please
take used batteries to an authorised collection point or
to a dealer.
NOTE:
Remove the backup battery during longer periods of
non-use.
Power supply
• Insert the grid plug into a properly installed three
prong socket with 230V, 50Hz. Connect the device
with the plug connector by inserting its plug into the
DC 5V jack (20) of the device.
• Make sure the grid voltage corresponds to the figures
on the rating plate.
• Time and preset settings are lost if mains power is
disconnected in case no backup battery is inserted.
CAUTION:
• The plug connector included must only be used with
this device. Don't use for other devices.
• Only use a power adapter with 5V (
ferent adapter may damage the device.
NOTE:
If the device is not used for an extended period of time,
the power adapter must be removed from the socket.
Set Time/Date on the Device
Unless using the "iDock Speaker" App in your iPod touch
or iPhone the time must be set manually on the device.
1. Press the TIME button (11). The hour display flashes.
2. Press the SET-/ SET+ buttons (9) to set the current
time.
3. Press the /ENTER button (8) to confirm your settings.
4. Press and hold the TIME button for approx. 3 seconds
to set the date.
5. Press the SET-/ SET+ buttons (9) to set the date.
6. Press the /ENTER button (8) to confirm your settings.
iPod Compatibility
Due to the many different iPod-Models and generations
currently available on the market, full compatibility can-
not be guaranteed. Before connecting your iPod, ensure
that it has a compatible interface.
The delivery includes adaptors for the following devices:
- iPod classic 160
nd
- iPod nano 2 generation
rd
- iPod nano 3 generation
- iPod touch
- iPhone 3G
Automatic time setting, weather display, etc. is only
available if an iPod touch or iPhone with installed App is
docked.
General Operation
Switch device on/off (4)
By pressing the /ALARM RESET button, you can put the
device into standby mode. Pressing the button again will
switch the device on. The display shows the current mode (8).
Display brightness
You can select or switch off the display brightness with
the DIMMER button (3).
ENGLISH
41
), a dif-