Technical Description; Setting Up And Initial Operation; Technical Data - Denios FL 8-K Mode D'emploi

4. Technical Description

The drum lifter has 3 wheelbase options and two lifting options:
Servo Type FL 8-K
Wheelbase narrow
Overall height
1540
(mm)
Lifting range (mm) 120 - 520
Lifting equipment with hydraulic pump
Oil fill volume
0.8
(litres)
The Servo Drum lifter is constructed as follows:
Stable frame with lifting mast
Adjustable drum gripper
-
Hydraulic pump with lifting cylinder or crank handle with cable winch -
-
2 fixed castors and 2 swivel castors (for the Ex version in electrically conductive design).
-

5. Setting up and initial operation

Drum lifter with hydraulic pump:
Before using the drum lifter for the first time, loosen the oil screw on the hydraulic
cylinder and raise the lifter with a load on board so that the air is removed from the
hydraulic system. Afterwards tighten the oil screw again. This method can also be
used for removing any air bubbles in the hydraulic system in the future.
If the oil screw is replaced with a screw with a hole (possibly included in the
delivery), the hydraulic system is permanently bled.
Adjust the adapter plate to suit the drum gripper
By changing the adapter plate the drum lifter can be adjusted to suit various starting heights and so the "no
load lift distance" (the amount the lifter is raised before the drum is lifted) can be reduced.
To do this, loosen the safety screws above the attachment holes (A or B) and then hang the adapter plate on
the frame at a different height. Now set the new attachment position using the safety screws.
Lifting height and gripping position
Regularly check the safety screws and if necessary tighten them.

6. Technical data

Maximum load: 300 kg
Permitted operating temperature / ambient temperature: -10°C to 40°C.
184355_BA_INT_010 Fasslifter Servo mit Fassklammer K
115215, 138379,181094, 181096
140832, 143858, 181095, 181097
FL 12-K
wide
1540
0 - 520
with hydraulic pump
0.8
Adapter plate attachment position
Seite 11 von 27 Seiten
FL 16-K F
wide
2130
0 - 1170
with hydraulic pump
1.0
Safety screw
FL 16-K H
wide
2130
0 - 1170
with cable
winch
-
B
A
Ausgabe 09/2015