Technical Description; Setting Up And Initial Operation; Technical Data; Operation - Denios FL 8-SK Mode D'emploi

4. Technical Description

The drum lifter has 3 wheelbase options and two lifting options:
Servo Type FL 8-K
Wheelbase narrow
Overall height
1540
(mm)
Lifting range (mm) 120 - 520
Lifting equipment with hydraulic pump
Oil fill volume
0.8
(litres)
The Servo Drum lifter is constructed as follows:
Stable frame with lifting mast
-
Adjustable drum clamp
-
Hydraulic pump with lifting cylinder or crank handle with cable winch -
-
2 fixed castors and 2 swivel castors (for the Ex version in electrically conductive design).
-

5. Setting up and initial operation

Drum lifter with hydraulic pump:
Before using the drum lifter for the first time, loosen the oil screw on the hydraulic
cylinder and raise the lifter with a load on board so that the air is removed from the
hydraulic system. Afterwards tighten the oil screw again. This method can also be
used for removing any air bubbles in the hydraulic system in the future.
If the oil screw is replaced with a screw with a hole (possibly included in the
delivery), the hydraulic system is permanently bled.

6. Technical data

Maximum load: 300 kg
Drum clamp clamping range: 530 – 610mm
Permitted operating temperature / ambient temperature: -10°C to 40°C.

7. Operation

Fitting to the drum
Check first of all that the drum is suitable, clean and undamaged. Check the edge of the drum in
particular.
1. Approach the drum to be loaded centrally with the drum lifter.
2. The drum clamp opens and closes automatically.
3. Lift the clamp to the level of the upper rim of the drum.
4. Adjust both sides simultaneously with the adjusting screw (1) until
the grippers fit against the wall of the drum. The sticker on the
frame (3) can be used to make sure both sides are adjusted evenly.
5. Lock the adjusting mechanism with the locking ring (2).
6. Lift the drum a little and then lower it in short jerky steps to check it
is securely held.
7. Lift the drum using the hand crank or the hydraulic pump.
8. The drum lifter is now ready to transport more of the same
type of drum without further adjustment.
212876_BA_INT_004 Fasslifter Servo mit Fassklammer SK
214474, 214475, 214476, 214477
214478, 214479, 214480, 214481
FL 12-K
wide
1540
0 - 520
with hydraulic pump
0.8
Seite 11 von 27 Seiten
FL 16-K F
wide
2130
0 - 1170
with hydraulic pump
1.0
FL 16-K H
wide
2130
0 - 1170
with cable
winch
-
Ausgabe 09/2015