Browser Configuration - Atlantis Land Net Fly AP1-54/P Guide De Démarrage Rapide

Before Configuration
This section describes the configuration required by LAN-attached PCs that
communicate with the Wireless Multi-Function Access Point, either to configure the
device or for network access. These PCs must have an Ethernet interface (or wireless
adapter) installed properly, be connected to the Wireless Multi-Function Access Point
either directly or through an external repeater hub or by wireless, and have TCP/IP
installed and configured with a fixed IP address that must be in the same subnet of
the Wireless Multi-Function Access Point. The default IP address of the Wireless Multi-
Function Access Point is 192.168.1.1 and subnet mask is 255.255.255.0. For example,
when the default network address of the default IP address of the AP is 192.168.1.1,
then the manager PC should be set at 192.168.1.x (where x is a number between 2
and 254), and the default subnet mask is 255.255.255.0.
Please follow the steps below for PC's network environment installation. First of all,
please check your PC's network components. The TCP/IP protocol stack and Ethernet
network adapter must be installed. If not, please refer to MS Windows related
manuals.
Before you configure this Wireless Multi-Function Access Point, you need to know the
following default settings:
 Username:admin
 Password: admin
 IP LAN address: (192.168.1.1), Subnet Mask (255.255.255.0)
 DHCP Server: disable
 SSSID= default, Channel=6, WEP/WAP=disable

1.6 Browser Configuration

Now open IE, go to Instruments menu, select the Connections tab and select one
of the following options:
 Never use remote connection
 Use remote connection if another network connection isn't available
27