Klarstein REINRAUM 2G Mode D'emploi page 17

Assembly
1 Do not connect the power plug yet. (It must be separated.)
2-3 Loosen the clamps on the container and remove the top assembly.
4 Remove the contents of the container. Check all the parts and match them
according to the picture above.
5a If anything is missing or damaged, contact customer service.
5b Put a wheel on each side of the container, making sure the wheels are tight.
Turn the container over and attach the brackets.
6a Insert a paper dust bag for dry vacuuming.
6b Use the foam filter to clean carpets.
7 Put the upper assembly back on.
8 Secure the structure with the two clamps.
9 Attach the suction hose to the associated connector.
10 Connect the suction hose to the suction tube. Place the end of the suction
tube on the suction bar. Connect the desired attachment to the suction tube.
Dust bag
• Always pull out the power plug before removing the upper structure.
• The filter is made of high-quality paper that catches small dust particles. This
filter is only suitable for dry vacuuming.
• The dust bag must be completely dry in order to collect dry dust, as a wet or
damp bag clumps up quickly and is difficult to clean.
• Carefully inspect the bag for tears and small holes. Even a small hole can
cause dust to be blown out. Never use a perforated or torn bag as this could
damage the motor and void your warranty. In that case, replace the bag
immediately.
EN
17