Tensai COO350 Manuel D'instructions page 4

To ensure that the appliance operates properly and to reduce
energy consumption, it is important that the appliance is
installed correctly.
Ventilation
The compressor and condenser generate heat and, therefore,
need to be ventilated properly. Rooms with no ventilation are not
suited for installation of the appliance. Therefore, it should be
installed in a room with an opening (window or French window) that
provide the appropriate amount of air re-circulation. It is also
important to install it in a free humidity room.
During installation, make sure not to cover or obstruct the grates
that allow for proper ventilation of the appliance. For proper
ventilation of the appliance, leave a space of at least 10 cm
between the sides of the appliance and any adjacent
cabinets/walls.
Away from Heat
Avoid positioning the appliance in a place where it is directly
exposed to sunlight or near an oven, cook top or the like.
Levelling
Install the appliance on a level and rigid floor. If the floor is not
perfectly horizontal, adjust the refrigerator by tightening or
loosening the front feet "E".
A
- Temperature Adjustment Knob
Turning the knob will adjust the temperature inside the appliance.
B
- Thermometer
C
- Removable Shelves (maximum load: 40 kg per unit)
D
- Fan System
Before starting the appliance, follow the installation instructions
(see "Installation").
Before connecting the appliance, clean the compartments and
accessories with lukewarm water and bicarbonate.
Insert the plug into the socket.
Adjust the temperature knob "A" to the required temperature
setting.
Using the refrigerator to its full potential
The temperature inside the refrigerator compartment automatically
adjusts itself according to the position of the thermostat knob "A" –
Min Máx.
-
The Cooling system is positioned on back wall of inside in the
fridge. It´s possible during the operating of the appliance, this wall
may be covered by ice or water drops, depending if compressor
was operating or stopped.
Install the Appliance Correctly
This means that the appliance should be installed away from
sources of heat or direct sunlight, in a well ventilated room.
Correct Temperature Settings
Set the temperature knob to one of the medium settings. Very low
temperatures will not only consume a great deal of energy, but will
neither improve nor lengthen the storage life of the food.
Before doing any cleaning, disconnect the appliance from the
electricity (by pulling out the plug or turning off the general
switch in your home).
4
Installation
The Appliance
Setting Up The Appliance
Efficient Usage of The Appliance
Energy Saving
Maintaining the Appliance
Electrical and Earth Connection
The appliance should not be turned on right after transportation.
Two hours is the advised time so that the oil from the motor-
compressor gets back to its original position.
Before proceeding with the electrical connection, make sure that
the voltage indicated on the rating plate, located inside the
appliance, corresponds to the mains voltage and that the socket is
fitted with a standard earth wire in accordance with safety
standards. If the socket is not fitted with an earth wire, the
manufacturer will not be held liability for any damages and or
injuries arising out of the use of the appliance. Do not use multiple
sockets or adapters.
Position the appliance in such a way that you can access the
socket where it is plugged in.
Insufficient power
The electrical socket must be able to handle the maximum power
load of the appliance, which is indicated on the rating plate located
inside the appliance.
The Fan System stops operating while the door is open.
E
- Regulation Feet
F
- Defrost water discharge hole
G
- Fan System Switch
At this point the fridge can be used.
NOTICE
Use average temperature settings to ensure optimum
performance and to save energy.
Some models may not have all the functions described.
This situation is normal and should not be of concern.
Use average temperature settings to ensure optimum performance
and to save energy.
Place only cold or lukewarm foods in the compartment, not hot
foods.
Remember that cooked foods do not last longer than raw foods.
Do not store liquids in open containers. They will increase humidity
in the refrigerator and cause condensation to form.
Shut the Doors
Open your appliance only when strictly necessary – every time you
open the door most of the cold air will be lost. In order to restore
the correct temperature, the motor will have to run and consume
energy.
Check the Door Seals
Keep the seals clean and pliable so that they fit closely against the
door to ensure that no cold air is lost.
WARNING: do not damage the refrigeration circuit.
Defrosting