Installation - Bessey PV2412 Mode D'emploi

3. Installation


Remove packing material and place the induction heater on a non-ferrous, stable, flat surface.
The box will normally contain the heater, a yoke or a set of yokes, the temperature probe, a
pair of heat-resistant gloves and a small container of lubricant.

Check that the supply voltage and current meet the specifications on the type plate to be found
on the back of the machine.

When the heater is not provided with a plug, a suitable plug has to be affixed by a qualified
electrician.

The wires should be connected as follows, there are 3 options depending on what type of
cable the heater is supplied with:
230V/120V induction heaters
Brown
Blue
Green/yellow
Black "1"
Black "2"
Green/yellow
400, 450, 500V induction heaters
Brown
Blue
Green/yellow
Black "1"
Black "2"
Green/yellow

Make sure that the supply cable cannot come into contact with the bearing that is to be heated.
Insert the plug into a shockproof wall socket.

Make sure that the bright sides of the yoke are lubricated sufficiently (improve contact, avoid
excessive vibration) and are aligned on the top of poles. Use supplied lubricant.

Use the main switch to switch on the current. The machine will emit a short bleep and the
display will show a "pre-set goal temperature" set by the manufacturer.

Connect the temperature probe by inserting the plug in the socket. Make sure that – and +
correspond on both plug and socket

The induction heater is now ready to be used in the temperature function mode.
Phase
Neutral
Ground
Neutral
Phase
Ground
Phase
Phase
Ground
Phase
Phase
Ground
Black Phase
White Neutral
Green Ground
Brown Phase
Black Phase
Green/yellow Ground
6